Anti-Plagiarism Policy

ChemClass Journal is committed to maintaining the highest standards of academic integrity and originality in scholarly publishing. The Journal strictly opposes all forms of plagiarism and unethical reuse of intellectual content. All manuscripts submitted for consideration must represent original work that has not been copied, duplicated, or misrepresented from other sources.

This Anti-Plagiarism Policy defines plagiarism, outlines acceptable standards of originality, and describes the procedures used by the Journal to detect and address similarity in submitted and published manuscripts.

DEFINITION OF PLAGIARISM

Plagiarism is defined as the use, reproduction, or presentation of another person’s ideas, text, data, figures, or intellectual output without proper acknowledgment or permission.

Forms of plagiarism include, but are not limited to:

  • Direct copying of text without appropriate citation;
  • Paraphrasing substantial content without attribution;
  • Submission of another author’s work as one’s own;
  • Self-plagiarism or redundant publication of previously published material without disclosure;
  • Unauthorised use of figures, tables, images, or data;
  • Improper citation or misrepresentation of sources.

 ORIGINALITY REQUIREMENT

All manuscripts submitted to ChemClass Journal must be original and not under consideration or published elsewhere, except in cases of preprint dissemination that have been properly disclosed.

 Authors are responsible for ensuring that:

  • The submitted work is their own intellectual creation;
  • All sources are properly cited and acknowledged;
  • Any reused material has appropriate permission and attribution;
  • The manuscript does not violate copyright or ethical publishing standards.

 SIMILARITY SCREENING AND DETECTION

ChemClass Journal screens all submitted manuscripts for similarity using recognised plagiarism detection software prior to peer review and/or during the editorial assessment process.

 The Journal evaluates similarity reports holistically, taking into account:

  • Context of matched text;
  • Nature of the content (methods, introduction, discussion, etc.);
  • Proper citation and quotation practices;
  • Acceptable reuse of technical or standardised terminology.

A similarity index alone does not determine plagiarism; editorial judgment is applied in all cases.

 ACCEPTABLE SIMILARITY LEVELS

While some overlap is unavoidable in scientific writing, ChemClass Journal generally considers:

  • A similarity index of 0–15% as acceptable, provided a proper citation is used;
  • Higher similarity levels may be acceptable in methods sections where standard procedures are described;
  • Similarity above acceptable thresholds will require editorial review and possible revision or rejection.

 Manuscripts exceeding acceptable similarity thresholds may be returned to authors for revision before peer review.

 SELF-PLAGIARISM AND REDUNDANT PUBLICATION

Self-plagiarism occurs when authors reuse substantial parts of their previously published work without proper citation or justification.

Redundant publication refers to the submission or publication of substantially similar content in more than one journal without full disclosure.

ChemClass Journal considers both practices unethical unless:

  • The prior publication is clearly cited;
  • The reuse is scientifically justified;
  • Appropriate permissions have been obtained;
  • The overlap is limited and transparent.

MANUSCRIPT SCREENING STAGES

Plagiarism checks may occur at multiple stages:

  • Upon initial submission (pre-review screening);
  • During peer review (if concerns arise);
  • After acceptance and prior to publication;
  • Post-publication if allegations or concerns are raised.

The Journal reserves the right to re-evaluate manuscripts at any stage of the publication process.

AUTHOR RESPONSIBILITIES

Authors are fully responsible for ensuring the originality of their work and must:

  • Properly cite all sources of information, ideas, and data;
  • Use quotation marks for verbatim text where applicable;
  • Obtain permission for copyrighted material;
  • Ensure originality in text, figures, tables, and data presentations;
  • Disclose any prior dissemination of the work (including preprints or conference papers).

Failure to comply with these responsibilities may result in rejection or retraction.

EDITORIAL ACTIONS IN CASE OF PLAGIARISM

Where plagiarism is detected or strongly suspected, ChemClass Journal may take one or more of the following actions:

  • Request clarification or revision from authors;
  • Reject the manuscript prior to or after peer review;
  • Inform the authors’ institution or funding body;
  • Retract published articles in cases of confirmed misconduct;
  • Impose submission restrictions on offending authors.

All cases are handled in accordance with the Journal’s Publication Ethics and Research Integrity policies.

FIGURES, TABLES, AND IMAGE PLAGIARISM

Plagiarism also includes unauthorized use of visual materials such as:

  • Figures and graphs;
  • Spectra and chromatograms;
  • Photographs and microscopy images;
  • Tables and datasets.

Authors must ensure that all visual materials are either original or used with appropriate permission and citation.

PLAGIARISM AND ACADEMIC INTEGRITY

ChemClass Journal recognizes that academic integrity is fundamental to scientific progress. The Journal does not tolerate any form of intellectual dishonesty and is committed to ensuring that all published content meets rigorous ethical and originality standards.

COMMITMENT TO BEST PRACTICES

ChemClass Journal follows international best practices in plagiarism detection and scholarly publishing ethics, consistent with COPE (Committee on Publication Ethics) guidelines.

The Journal continuously reviews its policies and tools to ensure effective detection and prevention of unethical publication practices.

CONCLUSION

Through this Anti-Plagiarism Policy, ChemClass Journal reinforces its commitment to originality, transparency, and integrity in scientific publishing. Authors, reviewers, and editors are collectively responsible for upholding these standards to maintain the credibility and reliability of the scientific record in chemistry and related disciplines.